MTech Computer Aided Engineering Laboratory-i syllabus for 1 Sem 2018 scheme 18CAEL16

Module-1 Experiments 0 hours

Experiment #1 Experimental and Numerical Analysis of Tensile Test

Part A: Experimental study of Tensile Test

Part B: Numerical Analysis of Tensile Test.

 

Experiment #2 Experimental and Numerical Analysis of Flexural Test

Part A: Experimental study of Flexural Test

Part B: Numerical Analysis of Flexural Test

 

Experiment #3 Numerically Calculation and MATLAB Simulation

Part A: Invariants, Principal stresses and strains with directions

Part B: Maximum shear stresses and strains and planes, Von-Mises stress

Part C: Calculate and Plot Stresses in Thick-Walled Cylinder

 

Experiment #4 Stress analysis of rectangular plate with circular hole under i. Uniform Tension and ii. Shear

Part A: Mat lab simulation for Calculation and Plot of normalized hoop Stress at hole boundary in Infinite Plate

Part B: Modeling of plate geometry under chosen load conditions and study the effect of plate geometry.

Part C: Numerical Analysis using FEA package.

 

Experiment #5 Single edge notched beam in four point bending.

Part A: Modeling of single edge notched beam in four point bending.

Part B: Numerical Studies using FEA. Part C: Correlation Studies.

 

Experiment#6 Torsion of Prismatic bar with Rectangular cross-section.

Part A: Elastic solutions, MATLAB Simulation

Part B: Finite Element Analysis of any chosen geometry.

Part C: Correlation studies.

 

Experiment #7 Contact Stress Analysis of Circular Disc under diametrical compression

Part A: 3-D Modeling of Circular Discs with valid literature background, supported with experimental results on contact stress.

Part B: Numerical Analysis using any FEA package. Part C: 2D Photo Elastic Investigation.

 

Experiment #8 Vibration Characteristics of a Spring Mass Damper System.

Part A: Analytical Solutions.

Part B: MATLAB Simulation.

Part C: Correlation Studies.