15AEL37A MEASUREMEN T AND METROLOGY LAB syllabus for AE



A d v e r t i s e m e n t

Module-1 0 hours

Calibration of Pressure Gauge

Module-2 0 hours

Calibration of Thermocouple

Module-3 0 hours

Calibration of LVDT

Module-4 0 hours

Calibration of Load cell

Module-5 0 hours

Determination of modulus of elasticity of a mild steel specimen using strain gauges.

Module-6 0 hours

Comparison and measurements using vernier caliper and micrometer

Module-7 0 hours

Measurement of vibration parameters using vibration setup.

Module-8 0 hours

Measurements using Optical Projector / Toolmaker Microscope.

Module-9 0 hours

Measurement of angle using Sine Center / Sine bar / bevel protractor

Module-10 0 hours

Measurement of alignment using Autocollimator / Roller set

Module-11 0 hours

Measurement of Screw thread Parameters using Two-wire or Three-wire method.

Module-12 0 hours

Measurements of Surface roughness, Using Tally Surf/Mechanical Comparator

Module-13 0 hours

Measurement of gear tooth profile using gear tooth vernier /Gear tooth micrometer

Module-14 0 hours

Calibration of Micrometer using slip gauges

Last Updated: Tuesday, January 24, 2023