1. Calibration of Pressure Gauge L1, L2, L3, L4
2. Calibration of Thermocouple L1, L2, L3, L4
3. Calibration of LVDT L1, L2, L3, L4
4. Calibration of Load cell L1, L2, L3, L4
5. Determination of modulus of elasticity of a mild steel specimen using strain gauges. L1, L2, L3, L4, L5
6. Comparison and measurements using vernier caliper and micrometer L1, L2, L3, L4
7. Measurement of vibration parameters using vibration setup. L1, L2, L3, L4
8. Measurements using Optical Projector / Toolmaker Microscope. L1, L2, L3
9. Measurement of angle using Sine Center / Sine bar / bevel protractor L1, L2, L3
10. Measurement of alignment using Autocollimator / Roller set L1, L2, L3
11. Measurement of Screw thread Parameters using Two-wire or Three-wire method. L1, L2, L3
12. Measurements of Surface roughness, Using Tally Surf/Mechanical Comparator L1, L2, L3
13. Measurement of gear tooth profile using gear tooth vernier /Gear tooth micrometer L1, L2, L3
14. Calibration of Micrometer using slip gauges. L1, L2, L3